Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.


How can we help?

Local Reviews
for Goliad, TX

ApplianceCare Rated 5.0 out of 5 stars based on 3 customer reviews

Map of Goliad, TX

Great service




Review of ApplianceCare

Very nice efficient man


Response from ApplianceCare:

Thank you for writing a review!


Map of Goliad, TX

Great job




Review of ApplianceCare


Response from ApplianceCare:

Thank you for writing a review!


Map of Goliad, TX

Great service




Review of ApplianceCare


Response from ApplianceCare:

Thank you!


Michael R.

Michael R.

DRYER AMANA AED4675YQ0 "The customer said she smelled a burnt odor, the air vent and hose were clear. Pulled the back panel to check if something was in the heat element, found something stuck to the element that was completely burnt, was able to remove it , the coils on the element were good, put everything back I. Place. The appliance is heating and working normal"

Near FM2441, Goliad, TX 77963
John L.

John L.

REFRIGERATOR WHIRLPOOL WRT318FMDB02 "Called Techline and spoke with Bruce, explained issues customer is having with unit.Tech line suggested to change sitting in freezer to maximum 12 I’ll let scared to travel into refrigerator section also to make sure thermostat was in direct contact with airflow into refrigerator and to restrict some of the airflow into the refrigerator from vents. May cut to direct air directly onto thermostat on insulation for vent, also restricted air in ventilation. This should keep refrigerator section from freezing."

Near Hencerling Rd, Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRT318FMDB02 "Called and spoke with the customer, customer wasn’t home, rescheduled customer for the next day. ; schdld next appmnt for 4/3 FRI !"

Near Hencerling Rd, Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRT318FMDB02 "The contents in RC are freezing, removed cover to check thermistor, no obstruction, ordered part to resolve issue ; ordrng 1 W10838965 (thermistor)"

Near Hencerling Rd, Goliad, TX 77963
Michael R.

Michael R.

DRYER AMANA NED5800HW0 "No power to the dryer. Removed cover to the terminal box and found the power cord was burned, removed power cord and replaced terminal. Removed front panel to confirm the fuse was good, put appliance back together and advised customer she would be responsible to get a qualified person to install new power cord, voltage is good at outlet"

Near Lassman Rd, Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRS571CIHZ01 "The gasket wasn’t sealing properly at the top on the refrigerator door. Used a heat gun to expand the gasket, the door is sealing properly, no air leaks"

Near Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRT318FMDB02 "Installed control, the appliance is working normal"

Near Hencerling Rd, Goliad, TX 77963
Michael R.

Michael R.

RANGE AMANA ACR4303MFB3 "Customer complaint is that the LR burner gets hot when the oven is on. The vent tube from the oven is on that side therefore it gets hot on that side and working as designed. Called and spoke with Andrew at whirlpool tech line to confirm, SR 7727287952, he confirmed the appliance is working as designed."

Near W Franklin St, Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRT318FMDB02 "The temperature in the refrigerator was 13.7 degrees at lowest setting, which is freezing up milk, drinks, etc. tried to turn off the appliance at the control, wouldn’t shut off, ordered control and rescheduled customer ; ordrng 1 W11353813 (CONTROL )"

Near Hencerling Rd, Goliad, TX 77963
Michael R.

Michael R.

WASHER MAYTAG MVWB765FW3 "F7E9,F2E1 error codes, cleared error codes. Tested the lid lock which is working normal, attempted to calibrate the appliance but the rotor was stuck and not grabbing the basket. Turned off the appliances and unplugged it, I was able to take it out of jam from underneath, also unplugged the harness from underneath and plugged them back in. Plugged the appliance in and was able to calibrate and perform a diagnostics test, completed with no issues or error codes, also tested the spin cycle on manual test twice to confirm the issue didn’t repeat itself, the appliance is working normal."

Near East End St, Goliad, TX 77963
Michael R.

Michael R.

WASHER WHIRLPOOL WTW4816FW2 "Installed part ordered, the inlet valve and appliance are working normal."

Near FM622, Goliad, TX 77963
Michael R.

Michael R.

WASHER WHIRLPOOL WTW4816FW2 "The inlet valve on the cold side isn’t working properly, removed the water hose, there is no obstruction, don’t have one in truck stock, ordered part to resolve issue issues ; ordrng 1 W11210459 (valve)"

Near FM622, Goliad, TX 77963
Michael R.

Michael R.

REFRIGERATOR WHIRLPOOL WRT519SZDM02 "Ice continues to build up on the back left corner of the freezer where the ice maker is, tested the ice maker, it’s working normal, the arm turns it on and off, no visual leaks, replaced the ice maker on previous visit, verified the evaporator is draining, unable to duplicate the issue. Called tech line and spoke with Chris SR7727015796 and explained all I’d done to the appliance, he said there wasn’t much more I could do if I couldn’t duplicate the issue, said he would document, and turn over to customer service if the customer is not satisfied"

Near FM622, Goliad, TX 77963
Michael R.

Michael R.

RANGE WHIRLPOOL WFE770H0FZ2 "Installed part ordered, the appliance is working normal"

Near W Fannin St, Goliad, TX 77963
Michael R.

Michael R.

RANGE WHIRLPOOL WFE770H0FZ2 "Called and spoke with the customer, asked if we could reschedule for tomorrow 01/24/2020. Rescheduled customer ; schdld next appmnt for 1/24 FRI !"

Near W Fannin St, Goliad, TX 77963
Michael R.

Michael R.

RANGE WHIRLPOOL WFE770H0FZ2 "Customer says it only gets to 250-275 degrees. turned the oven on to preheat, it never started heating up. Put the appliance in diagnostics and tested both elements, neither one of the bake elements would come on, pulled the oven out and removed the cover to the terminal block and found the red wire was loose and the post broke off the block, one of the wires burnt off, repaired the wire, and was able to put the post back in place so the customer could use the appliance until the part came in. Tested the appliance, it’s working normal at this time. Ordered terminal block and rescheduled customer ; ordrng 1 WPW10245259 (block-term)"

Near W Fannin St, Goliad, TX 77963
Michael R.

Michael R.

DRYER ROPER RED4516FW0 "The dryer was not heating, checked voltage, was not getting 110 on one leg. Reset the breaker, getting 240 at the outlet, powered on the dryer, the dryer is heating and working normal."

Near TX-239, Goliad, TX 77963
Michael R.

Michael R.

WASHER WHIRLPOOL WTW4950HW1 "F8E1 error, cleared error code and tested the inlet valve, it’s working normal. Calibrated and performed a diagnostics test, completed with no issues or error codes"

Near FM 1351, Goliad, TX 77963
Michael R.

Michael R.

WASHER MAYTAG MVWB865GW0 "F3E2, F8E1, F0E4, F2E1, cleared error codes and tested the inlet valve, not opening up on either side. Part was not in my bin, replaced with one from truck stock. Calibrated and performed a diagnostics, completed with no issues or error codes, the inlet valve and appliance are working normal ; used 1 W11165546 (VALVE) from stock"

Near S Temple St, Goliad, TX 77963
Michael R.

Michael R.

WASHER WHIRLPOOL WTW8040DW0 "F2E1 error code, cleared error code and tested the spin cycle the bearing is bad on gearcase, ordered part to resolve issues, wash plate just in case, tested the UI, there is no stuck keys, rescheduled customer ; ordrng 1 W10775188 (washplate) and 1 W10811956 (drum assy)"

Near Bethke Rd, Goliad, TX 77963
Michael R.

Michael R.

RANGE KITCHENAID KSGB900ESS2 "Error code F3E1, (opened drawer sensor), cleared error code and installed new sensor. Plugged the appliance in and it didn’t give F3E1 error code. Customer said only uses convection setting, turn on oven on that setting and preheated to 325 with no issues, no error codes, appliance is working normal"

Near US-183, Goliad, TX 77963
Michael R.

Michael R.

RANGE KITCHENAID KSGB900ESS2 Called and spoke with the customer and she said it gave the same error code F3E1. Ordered parts to resolve issue per tech sheet.; rqstng P&A on 1 W10833885 (sensor) and 1 W11100100 (cntrl-elec)

Near US-183, Goliad, TX 77963
Michael R.

Michael R.

RANGE KITCHENAID KSGB900ESS2 "Error code F3E1 was on the display stating that it was bottom sensor was open or shorted. Unplugged the appliance and plugged it back in after 30 seconds and it gave the error code again. Took back panel off and checked the sensor connection and it came off easy, reconnected the sensor and plugged it back in, didn’t break away easy this time, plugged appliance back in and didn’t give me the error code, it wasn’t making good connection at the temperature sensor. Preheated the oven to 350, completed with no issues or error codes, appliance is working normal."

Near US-183, Goliad, TX 77963
Michael R.

Michael R.

DISHWASHER WHIRLPOOL WDT730PAHZ0 "Put into diagnostics and display showed F9E2 error code, when the test started water was gushing out as soon as it called for water. Turned breaker off and pulled appliance out to look at the motor, found hose had come off of the motor, was able to put hose back in place. Turned breaker on and ran a diagnostics test, no longer leaking and the appliance is working normal."

Near S Stehle Rd, Goliad, TX 77963
Michael R.

Michael R.

RANGE WHIRLPOOL WFE515S0EB2 "Installed part ordered, the light and bake elements are working normal"

Near FM 1351, Goliad, TX 77963
Michael R.

Michael R.

RANGE WHIRLPOOL WFE515S0EB2 "The oven is not heating, went into diagnostics and there were no error codes, tested both bake and broil element, neither would come on as week as the light, connections were good and the voltage was good at both the outlet and the appliance, ordered control; ordrng 1 W11122551 (cntrl-elec)"

Near FM 1351, Goliad, TX 77963
Michael R.

Michael R.

DRYER WHIRLPOOL n/a The customer didn’t want me to work on the appliance at this time

Near Old Goliad Rd, Goliad, TX 77963
Michael R.

Michael R.

WASHER WHIRLPOOL WTW8900BC0 "Customer said it leaks on the right front corner, another company came out before and took it completely apart. Put appliance into diagnostics, error code F51, looked underneath and found the bolt to the rotor was left loose,tightened the bolt. Ran a diagnostics test completed with no error code, filled the tub with water manually and saw no visual leaks, the appliance is working normal."

Near Post Rd, Goliad, TX 77963