Inspected unit, found issue to be with gear case. Seal on gear case has broken spilling out all oil within gear case. Replace gear case and motor to resolve issues with this unit. Tested after installation all issues resolved.

Customer states they were using the oven to bake and on the third batch of and completely lost power. During my visit this time around checked voltage at the harness wire and it is lacking. Switch breaker tested unit again still poor voltage at harness. Informed customer they would have to contact professional electrician to resolve issue.

Inspection of unit shows error code for motor fault as well as long Phil no Phil. Manually testing unit shows cold water valve seized shut.Service pointer in relation to this unit for this issue in regards to actuator needing to be replaced. Replaced actuator and water valve calibrated unit ran verification cycle issue resolved; used 1 W10869800 (Valve) from stock

Installed components tested unit issue resolved

Customer complaint of oven not working as well as back left melt burner. Inspection of unit shows good voltage its a little low but within range. Also an error code on the unit for stuck button as well as internal board failure. Replace control board and infinity switch to resolve issue.