Appliance Repair Concepcion Texas

ApplianceCare Rated 5.0 out of 5 stars based on 1 customer reviews

We serviced a
WHIRLPOOL DRYER
Model WED7120HW1
Near Concepcion, TX 78349
Adam
Job Details: 02/17/2022
Replace only HMI tested unit issue Resolved
We serviced a
MAYTAG WASHER
Model MVWB865GW0
Near Concepcion, TX 78349
Adam
Job Details: 02/10/2022
According to customer lid and locking problem was never chief complaint with the unit. But during my first visit I was unable to properly test components because lid would not lock. Now that lid is functioning properly and closes and locks correctly customers chief complaint is that it makes a loud noise during an agitation cycle. Diagnostic shows error code for lid lock failure only. And manually testing all functions show good working order. No strange noises. Calibrated unit and running verification cycle Result in perfect functionality of the unit. Cannot duplicate noise customer is concerned about. Issue resolved
We serviced a
WHIRLPOOL DRYER
Model WED7120HW1
Near Concepcion, TX 78349
Adam
Job Details: 01/20/2022
Customer complaint of unit not powering on. Inspection of unit shows good voltage but no response coming from interface. Service pointer for this unit suggest replacing both control board and interface to resolve issue.
We serviced a
WHIRLPOOL WASHER
Model WTW4816FW2
Near Concepcion, TX 78349
Adam
Job Details: 01/11/2022
Customer complaint again same as previous visit unit not seeming to wash. Inspection of unit shows no error codes. But further inspection shows agitator completely free spinning from gear case. Teeth on agitator have completely stripped out as well as teeth on gear case have worn away almost completely. Will need to replace Complete agitator as well as gear case to resolve issue.
We serviced a
MAYTAG WASHER
Model MVWB865GW0
Near Concepcion, TX 78349
Adam
Job Details: 12/16/2021
Customer complaint of noise during operation. Inspection of unit shows Left corner of lid is broken which is causing lead to rise at a funny angle and not allowing lead to lock. Further inspection shows error codes for lid lock error as well as lid not open. I was able to hold the lid and calibrate unit and run verification cycle with no strange noises. Will need to replace lid and lock to resolve issue.
Juan
Concepcion, Texas
09/24/2019
Great Service
Thank you for reviewing us.
Overall Experience